Gewikkeld draad trimmers (Algemeen)

door Piet van der Pol @, Alblasserdam, 14.03.2021, 11:44 (1110 dagen geleden) @ Pandu Rajan

The wire should always be connected tot the joint (a). An unused trimmer has a ceramic tube full of wire. The capacity is than always higher then the value that is neccesary in the circuit. During trimming the wire is unwinded from the tube until the right value is reached in the circuit. Then the loose wire is cut, en the circuit is trimmed properly.

Piet


Berichten in deze thread:

 RSS Feed van deze thread

powered by my little forum