BX645A (Algemeen)

door Sieme , Niekerk, 10.05.2024, 12:24 (195 dagen geleden) @ Pandu Rajan

Dear Mr. Rajan
Referring to your,' How to adjust' question:
Figure no.4 in the document you sent along in your first message on this matter is showing the situation where the band K.G.2a is selected.Make sure the contact is on the spot,that is in the middle of its assigned sector ,if the reversing wheel then is in the position as shown on the drawing it is ok,otherwise losen the sk6 gear and without disturbing the switch setting adjust the reversing gear.The hole in the switch gearwheel and pin on the reversing gearwheel on 6 o clock .
The motor will show its resting position when no band is selected and power is on.Adjusting the arrow is an cosmetical issue but it is nice to see it on the dot at each wave band.
I hope this will answer your question.,
rgds,
Sieme

--
het experiment heeft altijd gelijk